Programming or Troubleshooting
Pet Stop® Receiver Collars

Most Pet Stop® dog fence receiver collars provide many programming options and can be tuned to a wide range of correction settings.
The fence collars can also be programmed to work with most other electronic pet fencing systems, including Invisible Fence® brand systems.

Below, we have a couple of videos that will help you guide you through setting the correction levels on your Pet Stop® receiver collar.

Programming your Pet Stop® Receiver Collar with an OT-200 Transmitter

This video will help you ONLY if:

  1. You are using the Pet Stop® UltraElite Series 2
    The original UltraElite collar (without the #2 printed on it) will not work with this programming.
  2. Your system has been set to the “80” series of correction settings.
    If you purchased your pet fencing system from Hidden Fence Company, “80” is the default setting that we originally set your system to.
UltraElite and UltraElite Series 2

Pictured: Pet Stop® UltraElite and Pet Stop® UltraElite Series 2

Video Transcript

Programming SII Transcript

Video Runtime: 53 seconds

0:00 – To change the setting, first remove the cover by depressing the small tab on the bottom…

0:08 – Press and hold the training button until 98 flashes…

0:12 – Move the receiver in until the light comes on, then press the top button and count the number of flashes.

0:24 – This time it will be at level 3, with 3 flashes.

0:31 – To increase the level, you have to raise it one level at a time…

0:42 – To go down a level, press the bottom button.

Programming your Pet Stop® Collar with an OT-300 Transmitter

Video Transcript

OT-300 Programming

Video Runtime: 47 seconds

0:00 – To program the series 2 receiver with the OT-300 transmitter, press and hold the center button until the number 98 flashes in the display…

0:13 – Move the receiver in. When the red light appears, we can increase the level.

0:20 – The number of flashes indicate the correction level.

0:29 – To decrease the level, we would use the down button.

0:42 – To return it to normal operating mode, just press the center button.